Recoil Stabilizer™ Replacement Isolation Foam

Maintain or customize your Recoil Stabilizer™ by replacing a worn or damaged foam component, or by adjusting the firing angle to better suit your studio setup. Replacement foam is available in all stock Recoil sizes and angles, ensuring a perfect fit for your existing units.

Installation Instructions:

1. Apply the spray adhesive evenly to the Recoil’s steel plate.

2. Position the replacement foam carefully onto the plate, ensuring full contact across the surface.

3. Allow the adhesive to set according to the manufacturer’s instructions before mounting the Recoil Stabilizer.

This simple process restores the acoustic performance of your Recoil Stabilizer while allowing you to fine-tune your monitor placement for optimal isolation and transient response.